Firesense 61185 Manuel d'utilisateur

Outdoor Patio Heater Item#60368,60485,60786,60788,61185,61444,61546,61547, 61629,61726,61727,61728,61729,61730,61735,61736,61737, 61738,61739,61740,6

10 9. While supporting heater, tilt the Head Assembly (C) and slide 3 Large Flat Washers over the Reflector Studs. Place the Reflector Assemb

11 A minimum supply pressure of .5 psi is required for the purpose of input adjustment of propane gas. Storage of an appliance indoors is per

12 Leak Test 1. Make 2-3 oz. of leak test solution (one part liquid dishwashing detergent and three parts water). 2. Apply several drops

13 Lighting: NOTE: For initial start or after any cylinder change, hold the control knob in for 2 minutes to purge air from all gas lines before pr

14 Shut Down: 1. Turn control knob clockwise to OFF while depressing the knob. (Normally, burner will make a slight popping noise when extin

15 To enjoy years of outstanding performance from your heater, make sure you perform the following maintenance activities on a regular bas

16 If you have any questions regarding this product, please call our customer service hotline at 1-866-985-7877, 9a.m. – 6 p.m. (EST), Monday – Fri

17 For questions regarding this product or to purchase replacement parts, please call our customer service hotline at 1-866-985-7877, 9a.m. – 6 p.

18 1 YEAR LIMITED WARRANTY – Customers in the Continental US All components are warranted for a period of 1 year after date

2 Table of Contents…………………………………...Page 2 Before You Begin...Page 2 S

3 SAFETY INFORMATION

4 SAFETY INFORMATION

5 PACKAGE CONTENTS

6 PREPARATION Before beginning assembly of this appliance, make sure all parts are present. Compare all parts

7 1. Attach Wheel Assembly (K) to Base (J). Align holes in Wheel Assembly with corresponding holes in Base, and insert 2 - Small Bolts through

8 3. Attach the Lower Post (G) to the Post Supports (I). Once you have tightened the bolts holding the Post Supports (I) to the Base (J), alig

9 6. Attach Reflector Studs to the top of the Head Assembly (C). Insert 1 Reflector Stud through 1 Large Flat Washer and into hole on the top